The :set command sets two types of options: GHCi options, which begin with ‘+” and “command-line” options, which begin with ‘-’.
GHCi options may be set using :set and unset using :unset.
The available GHCi options are:
Normally, any evaluation of top-level expressions (otherwise known as CAFs or Constant Applicative Forms) in loaded modules is retained between evaluations. Turning on +r causes all evaluation of top-level expressions to be discarded after each evaluation (they are still retained during a single evaluation).
This option may help if the evaluated top-level expressions are consuming large amounts of space, or if you need repeatable performance measurements.
Display some stats after evaluating each expression, including the elapsed time and number of bytes allocated. NOTE: the allocation figure is only accurate to the size of the storage manager's allocation area, because it is calculated at every GC. Hence, you might see values of zero if no GC has occurred.
Display the type of each variable bound after a statement is entered at the prompt. If the statement is a single expression, then the only variable binding will be for the variable ‘it’.
Normal GHC command-line options may also be set using :set. For example, to turn on -fglasgow-exts, you would say:
Prelude> :set -fglasgow-exts |
Any GHC command-line option that is designated as dynamic (see the table in Section 4.18), may be set using :set. To unset an option, you can set the reverse option:
Prelude> :set -fno-glasgow-exts |
Section 4.18 lists the reverse for each option where applicable.
Certain static options (-package, -I, -i, and -l in particular) will also work, but some may not take effect until the next reload.